Home > HPI Savage Flux > HPI Savage Flux Aftermarket Parts >

TCS Crawlers 4mm Bolt Upgrade for Integy Rear Hub Carrier (T6979) HPI Savage Flux HP 2350
TCS Crawlers 4mm Bolt Upgrade for Integy Rear Hub Carrier (T6979) HPI Savage Flux HP 2350


 
TCS Price: $4.99

Stock Status: In Stock


Product Code:
SKU77774

Qty:

Description
 
Grade 12.9 bolt is much stronger than the stock Integy pin and must be trimmed to length once the locknut is installed. Install the bolt and extra nut, trim, then back out the extra nut to clean the threads. Then use the same extra nut to do the second bolt. Cut the second bolt and remove the spare nut to clean the threads. Install the second un-used nut. Includes 2 bolts and 3 locknuts.

Average Rating: Average Rating: 5 of 5 5 of 5 Total Reviews: 4 Write a review »

  0 of 0 people found the following review helpful:
 
5 of 5 4mm bolt upgrade for rear c blocks...savage flux May 21, 2016
Reviewer: edgar slegt from wasaga beach, ON Canada  
awesome product...now I do not have to worry about knocking off a c-clip and losing the shaft, possibly crashing and wrecking my r/c...thank-you...p.s. my local hardware supplier did not have these...?

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Asum bolt upgrade September 22, 2014
Reviewer: Dan Kuzminsky from Oak Creek, CO United States  
these are just sweet. I bent the pins that came with the hubs, and they pulled out and put an end to the fun, but I don't think these will!!!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Better than stock September 22, 2014
Reviewer: Keanuonalani Frank from Aiea, HI United States  
The stock pins that come with the Integy Rear Hub Carriers is way to soft...use these, no worries after that

Was this review helpful to you?

  0 of 0 people found the following review helpful:
 
5 of 5 Bent one, now I have 6 spare July 19, 2014
Reviewer: Chris Armstrong from Ferndown, Dorset, England  
I drive my truck hard. These are so much nicer than the stock integy pin. Who likes C clips anyway? I am going to try and make these bolts work for the front hub carriers too, as they use a similar pin with c clips. Not sure if it’ll work, but next time I break the truck down I’ll try. They’re super strong, only bent one (and only by a small amount). Recommended!

Was this review helpful to you?