Nav Menu 1
Nav Menu 2
Site Help / FAQ
Stay on the radar
Sign up for our newsletter and be the first to hear about great deals!
Rock Racing - U4RC
Rock Racing Model Specific Aftermarket Parts
Combo Deal: TCS Crawlers Yeti Winch Mount, KMS K3 Servo Winch, and HeyOK Performance Winch Controller
List Price: $125.99
Stock Status:(Out of Stock)
Email me when Back-In-Stock
This combo deal includes:
TCS Crawlers Yeti Winch Mount
KMS Winches K3 Servo Winch 180 oz K3SW180 (3S compatible)
HeyOK Performance Winch Controller with 4 Amp Relay Contacts for 3 position Channel with JST Connector "Yellow Jacket" 3PWR4JSTY
Servo winch requires a separate fairlead. You can buy the Blue Monkey BM-257 or make your own by using a rod end for the line to go through to keep the line centered on the spool. Servo is 3S compatible.
Technical note from KMS:
1- You must turn your radio on before powering up the servo winch.
2- If you use a radio that does not have end point adjustments on the 3rd channel, you must use a 2 position HeyOK winch controller. You could burn up the winch motor if not set up correctly.
About the HeyOK controller:
Yellow Fused Version. Self-resetting fuse will prevent the winch from drawing too much current and destroying the gears in your servo winch. This is the brute force method of motor control. These controllers don't have the voltage limitations that the normal winch controllers have!
Rather than relying on semiconductor components to take care of power switching, these units make use of relay contacts. This means super low "on" resistance which ensures that the maximum amount of power will be delivered to your winch.
These controllers are recommended for servo winch operation but they will work on 3Racing and RC4WD DC powered winches too.
The contacts in the 4 amp relay exceed 20 volts. This is way more voltage than any servo winch or 3Racing etc winch can safely work with. Keep in mind that as you increase the working voltage, you increase the current flowing through the relay contacts to your winch motor.
Plug the controller into a free three position or linear channel on your receiver. Connect a battery that you want to run the winch to the other connector. The white wires get soldered to your winch motor.
The controller only uses a small amount of power from the receiver to power its signal decoding electronics and to operate the relay coils. When the winch is not winding in or out, the relay contacts provide a short across the motor to "brake" the winch load which helps to keep the line from winding out.
Designed to work with a radio/transmitter that has a 3-position third (or other) channel.
Axial Pinion Gear 32P 16T - Steel (5mm Motor Shaft - Fits Yeti) AX30842
$10 off SSD Diamond Centered Rear Axle for Axial Wraith (Black) SSD00043
Hot Racing Yeti Aluminum Steering Post with Ball Bearing YET47M06
Axial Yeti, Wraith, SCX10 Optional Ratio Gear Set 43/13 AX30402
SSD Centered Rear Axle Shafts for Axial Wraith SSD00040
Venom 35C 3S 11.1V 3300mAh Hard Case LiPO Battery with Universal Plug System (perfect light weight battery for the Axial Yeti) 15094
Lattice Innovations Slim Shifts Flexible Offset Hubs (compatible with Vanquish SLW) (includes 4 sets of hubs)
Lattice Innovations Shifts Flexible Offset Hubs (compatible with Vanquish SLW) (includes 4 sets of hubs)
Share your knowledge of this product.
Be the first to write a review »